Skip to content

Manufacturing Tooling News

Development, Sourcing & Lifecycle Insights for Manufacturing Tooling

  • Home
  • About Us
  • Tooling Development
    • Tooling Design & DFM
    • Prototyping & Trial Runs
    • Tooling Modification
  • Tooling Sourcing & Procurement
    • RFQ & Tooling Quotes
    • Supplier Evaluation & Selection
    • Tooling Cost & Procurement
    • Tooling Requirements & Purchasing
  • Tooling Quality & Acceptance
    • Tooling Inspection
    • Trial & Sample Approval
    • Tooling Acceptance
  • Tooling Lifecycle
    • Tooling Maintenance
    • Tooling Repair & Refurbishment
    • Tooling Performance & Wear
    • Tooling Replacement & End of Life

Category: Tooling Development

Guidance on developing manufacturing tooling from design planning through trials, revisions, and preparation for production.

What Tooling Problems Often Need Changes After Trial Runs

Posted on 2026-10-282026-10-28
What Tooling Problems Often Need Changes After Trial Runs
Tooling Development, Tooling Modification

A tooling trial rarely goes exactly as planned. The first samples may look acceptable, but a closer inspection can reveal a hole that sits slightly off position, an edge with unwanted burrs, or a part that sticks when it should come out easily. Sometimes the problem is less obvious. The tool completes a working cycle, ... Read More "What Tooling Problems Often Need Changes After Trial Runs" »

What Should Be Done When First Trial Samples Are Off Size

Posted on 2026-09-152026-09-16
What Should Be Done When First Trial Samples Are Off Size
Prototyping & Trial Runs, Tooling Development

The first tooling trial is often the point when a design moves from drawings and discussions into something that can be checked in the real world. A sample may look close to the intended shape, yet a measurement can show that one area is too large, too small, too thick, or too thin. That does ... Read More "What Should Be Done When First Trial Samples Are Off Size" »

How Should Tooling Part Fit Dimensions Be Confirmed

Posted on 2026-09-012026-09-16
How Should Tooling Part Fit Dimensions Be Confirmed
Tooling Design & DFM, Tooling Development

When several tooling parts work together, their fit cannot be decided by looking at one part alone. A locating pin, guide component, insert, plate, slide, or other mating part may each have a suitable dimension on its own, yet the assembled tooling can still feel too tight, too loose, or difficult to use. This is ... Read More "How Should Tooling Part Fit Dimensions Be Confirmed" »

Recent Posts

  • Why Does Tool Wear Change Finished Part Dimensions
  • What Documents Are Needed Before Tooling Final Acceptance
  • What Makes Up the Cost of Manufacturing Tooling
  • What Tooling Problems Often Need Changes After Trial Runs
  • What Should a Tooling Repair Record Include

Archives

  • November 2026
  • October 2026
  • September 2026

Categories

  • Tooling Lifecycle
    • Tooling Performance & Wear
    • Tooling Repair & Refurbishment
    • Tooling Maintenance
  • Tooling Quality & Acceptance
    • Tooling Acceptance
    • Trial & Sample Approval
    • Tooling Inspection
  • Tooling Sourcing & Procurement
    • Tooling Cost & Procurement
    • Supplier Evaluation & Selection
    • RFQ & Tooling Quotes
  • Tooling Development
    • Tooling Modification
    • Prototyping & Trial Runs
    • Tooling Design & DFM

Powered by Manufacturing Tooling News © 2026

Copyright © 2026 Manufacturing Tooling News.

-->